Large Color Touch Screen Operation
Front panel operation of the M2000 Power Analyzer is accomplished completely using its large touch-sensitive display. There are no buttons or dials to distract from the rich data displays provided to the user.
Power Measurements
The power data screen displays Frequency, Voltage, Current, Crest Factor, Power, VA, VAR and Power Factor data for any selected channel or group of channels. Up to three different channel groups can exist in a single M2000 power analyzer.
Harmonics Analysis
Harmonic Analysis is performed on each input of each channel configured to do so. There is no restriction on the number of channels configured for harmonic analysis other than max. available inputs (8). Up to 500 harmonics per channel can be analyzed.
Scope View Mode
The scope view display time domain information similar to a digital storage scope. Up to six signal can be displayed at once, each one having its own vertical scaling, offset and color. Common scope functions like timebase trigger level and trigger offset are user settable as well.
Vector View Mode
A polar chart graphically displays the fundamental voltage and current vectors for the selected channel or channel group. For multi-phase groups, the inter-phase voltages and non-measured neutral phase vectors are displayed. The user can enable the display of and select the color of each vector up to a maximum of 10.
Standby Power Measurements
Designing products with very low standby current is important to minimize waste. The standby power measurement mode of the M1001 allows certification to the ENERGY STAR / EN62301 standard.
Product Burn-in Data Logging
The M2000 features built in standby power testing in accordance to EN50564:2011 (replaces IEC62301) which can be started by the pressing the STBY POWER screen touch key.
Avionics & Defense Power Test
The high bandwidth and accuracy of the M2000 Series supports a wide range of defense and avionics measurement applications for 400Hz fixed frequency or 360Hz to 800Hz wild frequency electrical equipment. Special measurement modes are provided for common avionics power compliance test standards such as RTCA DO-160, Section 16 or Boeing 787B3-0147.
IEC 61000-3-2 & 61000-3-12 Harmonic Emissions Test
Products destined for Europe must meet Harmonics emissions limits as determined by harmonized standards IEC 61000-3-2 and IEC 61000-3-12. The M2000 can be used to check products during development for compliance so formal CE approval can be obtained more easily and less costly than finding problems later in the product development cycle.
